Schleuniger - Pneumatic Crimping Machine CT30S
SCHLEUN-100000491816
The CT 30 S Pneumatic Crimping Machine is designed for loose-piece crimping applications.
Schleuniger - Pneumatic Crimping Machine CT30S
SCHLEUN-100000491816
The CT 30 S Pneumatic Crimping Machine is designed for loose-piece crimping applications.
Need assistance, installation and/or training?
Call +32 (0)14 42 44 01 or contact us
Description
The CT 30 S Pneumatic Crimping Machine is designed for loose-piece crimping applications. Its scissor-action crimping head delivers up to 14 kN (1.6 tons) of force. The crimping head is spring-loaded which helps to properly and safely position the terminal before crimping. The ergonomic 15 degree tilt of the machine provides an optimal viewing angle of the crimping area for safe operation. The CT 30 S is very simple to set up and operate. A wide range of crimping dies are available to meet your application needs.
Specifications
Crimping Force | 14 kN (1.6 tons) |
Conductor Cross Section | Insulated Closed Barrel: Up to 6 mm2 (10 AWG) Non-Insulated Closed Barrel: Up to 10 mm2 (8 AWG) Wire End Ferrules: Up to 50 mm2 (1/0 AWG) |
Internal Working Air Pressure | 6 bar / 90 psi |
Crimp Action | Partial Scissor |
Ram Speed (no load) | Approximately 1cm/s |
Safety Shield | Fixed around the crimping dies |
Downloads
The CT 30 S Pneumatic Crimping Machine is designed for loose-piece crimping applications. Its scissor-action crimping head delivers up to 14 kN (1.6 tons) of force. The crimping head is spring-loaded which helps to properly and safely position the terminal before crimping. The ergonomic 15 degree tilt of the machine provides an optimal viewing angle of the crimping area for safe operation. The CT 30 S is very simple to set up and operate. A wide range of crimping dies are available to meet your application needs.
Type | Die Based Crimping |
---|